Basement flooding right now? Stay out of standing water near outlets and call (508) 526-9693.
Emergency Basics — Brockton, MA

One valve stops the flood. Find it before you need it.

When a pipe lets go, the fastest way to limit the damage is to close the main water shutoff. Here's where it usually is, how to close it, and what to do if it won't budge.

"In a water emergency, how do I shut the water off?" is asked constantly on plumbing forums — often by someone typing it while water is still running. The answer is simple once you've found the valve, which is why the best time to read this is before anything breaks.

Where the main shutoff usually is

In most Brockton homes the water service comes in through the basement wall or floor on the side facing the street. Look there first, near the water meter. There is normally a valve on the house side of the meter, and often one on the street side too. Either will stop the water to the house.

  • No basement? Check a utility closet, the area near the water heater, or under the kitchen sink on a slab home.
  • Multi-family or condo? Your unit may have its own shutoff, but the building main is often in a shared basement. Know where both are.
  • Can't find one at all? That's worth fixing before the next cold snap — a plumber can locate it or add one.

How to close it

  • Round wheel handle (gate or globe valve): turn it clockwise until it stops. That can take several full turns. Righty-tighty applies.
  • Lever handle (ball valve): turn it a quarter turn so the lever sits across the pipe, not in line with it. Across means off.

Then open a faucet on the lowest floor to drain pressure and the water still in the pipes, so less of it comes out wherever the break is. If the leak is at the water heater, close the heater's cold inlet valve too.

If the valve is stuck

Valves that haven't moved in years often seize. The advice plumbers give most often online is to work it gently, not hard:

  • Grip the handle (or the flats right at the stem) with an adjustable wrench or channel-lock pliers and apply steady pressure. Small, firm movements work better than one big pull.
  • Don't add a long pipe for leverage. Old gate valves can snap at the stem, and then you have a leak at the valve itself.
  • If it turns but the water doesn't stop, the gate inside has likely worn or broken loose. Keep the faucet open to drain the lines and move to the next step.

When the house valve won't stop the water

There is usually a curb stop on the service line outside, typically under a small cover near the property line or sidewalk. It takes a special key and belongs to the water utility, so call the city's water department emergency line and an emergency plumber at the same time. If water is coming in near the foundation before it reaches your house valve, the break may be on the service line itself — see signs your main water line is leaking underground and our main water line repair page.

After the water is off

  • Shut off power to any wet area you can reach safely from a dry spot.
  • If the water heater is drained or the house will be without water for a while, turn the heater to vacation or pilot, or switch off its breaker if electric.
  • Follow the steps in what to do first if a pipe bursts.
  • When the repair is done, open the main slowly. Opening it all at once can knock loose sediment and send a pressure surge through the lines.

Do this now, while nothing is wrong

Find the valve, make sure you can reach it without moving boxes, and tag it so anyone in the house can find it. Try closing and reopening it once. If it's seized, leaking at the stem, or doesn't fully stop the water, that's the moment to have it replaced — not at 2 a.m. in January.

Valve won't close?

The dispatcher
answers now.

(508) 526-9693

Real human, real truck if you need one.